Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Access Control Cost in West Palm Beach?
Gate access control in West Palm Beach typically costs $650 to $1,600 for a single-family driveway system and $2,400 to $8,500+ for a multi-tenant or commercial entry, depending on the number of access points, the reader technology, and whether wiring already exists. A basic keypad-and-remote setup on an existing operator often lands near the low end, while a full telephone entry system with video and loop detectors runs toward the top. These are installed prices from the West Palm Beach market in 2026, not national averages.
We install and service access control across the county, from single residential driveways off Flagler Drive to gated communities in Ibis and commercial lots near the Palm Beach International Airport corridor. Because we’re factory-familiar with nine gate brands – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule – we can usually quote the access system that fits the operator you already own instead of pushing a full replacement. Call (855) 360-5979 for a free estimate.
Key Takeaways
- Residential driveway access control: $650 – $1,600 installed.
- Commercial or multi-tenant entry: $2,400 – $8,500+.
- Adding a keypad or card reader to a working operator is the cheapest path at $300 – $750.
- Hurricane-rated wiring runs and salt-air corrosion add real cost in coastal Palm Beach County.
- Labor and travel on the barrier islands and western communities can move the total either direction.
Gate Access Control Cost Breakdown (2026)
Here’s how the line items break down in the West Palm Beach market. These ranges reflect installed cost, including the device and typical labor for a standard residential or light commercial gate.
| Access Control Component | Typical Installed Cost |
|---|---|
| Keypad entry (wired or wireless) | $300 – $750 |
| Long-range remote receiver (up to 4 remotes) | $250 – $600 |
| Proximity card / fob reader (single door or gate) | $550 – $1,200 |
| Telephone entry intercom (DoorKing-style) | $1,400 – $3,200 |
| Video intercom with call-forwarding | $1,800 – $4,000 |
| Loop detector & vehicle sensor | $400 – $950 |
| Photocell / safety beam set | $180 – $450 |
| Control board replacement (brand-dependent) | $350 – $900 |
| New wiring run (per 100 ft, trench included) | $400 – $1,200 |
| Full residential access package (keypad + remotes + loop) | $650 – $1,600 |
| Commercial multi-tenant entry (telephone + video + 2 loops) | $2,400 – $8,500+ |
What pushes a job toward the top of these ranges? Multiple access points, long wire runs to a detached gate, video capability, and integration with an older operator that needs its control board updated first. What keeps it at the bottom? A working operator that already has power at the gate and just needs a modern reader dropped in. A gate that fails again isn’t a repair – it’s a callback, so we’d rather quote the loop detector and safety beams up front than skip them and return a month later.
What Affects Gate Access Control Pricing in West Palm Beach
- Coastal salt air and humidity. Gates on Palm Beach and the closer blocks of West Palm Beach face constant salt-air exposure. Corroded terminals and rusted connectors are common, and we sometimes find the access device failed simply because the wiring junction is green with oxidation. We quote sealed enclosures and marine-grade connectors here more often than in inland cities.
- Hurricane-season wind and surge. Palm Beach County’s storm season means surge protection on the control board and secure conduit runs matter more than in most of the country. A reader that isn’t surge-protected can be knocked out by a single nearby lightning strike in a June squall.
- Barrier island vs. western communities. Travel and access differ across the county. A gate off South Ocean Boulevard has different logistics than one out in Wellington or Royal Palm Beach, and that shows up in labor time.
- Existing operator brand. If your gate runs a Linear or LiftMaster operator, adding a compatible keypad or receiver is straightforward. An older or non-standard operator may need a control board or interface module first, which adds cost but avoids a full replacement.
- Number of access points. A single driveway gate is one price. A community or commercial property with entry and exit gates, a pedestrian door, and a visitor lane multiplies both hardware and wiring.
- Wiring already in place. If power and low-voltage lines already run to the gate, the job is faster and cheaper. If we’re trenching a new run through established landscaping or a paver drive, expect the wiring line item to climb.
One local note worth stating plainly: in the older neighborhoods near downtown West Palm Beach, we regularly find access systems wired into gate operators that were installed decades ago and never updated for modern readers. That’s rarely a replacement conversation – it’s usually a control board and interface job, which is exactly the kind of work a brand-agnostic specialist should handle without steering you toward a new gate. You can read more about the service itself on our Gate Access Control in West Palm Beach page.
How to Save on Gate Access Control
You don’t need the most expensive reader on the market to control who gets through your gate. A few practical moves keep the number down:
- Keep a working operator. If your gate motor and control board still run, adding a keypad or card reader is a few hundred dollars instead of a few thousand. We test the operator before quoting anything else.
- Match the reader to real use. A single-family home rarely needs a video intercom. A keypad plus a long-range receiver often covers everything a household needs for well under $1,000.
- Bundle during installation. If you’re installing a gate or a new operator, adding access control at the same time saves a separate trip and often the wiring run.
- Fix corrosion early. A $180 photocell set replaced on schedule beats a $900 control board after salt air and a storm finish the job.
- Get the estimate in writing. Free, itemized estimates keep the job honest and let you compare line by line. Call (855) 360-5979 and we’ll walk your gate and quote the real numbers.
FAQs – Gate Access Control Cost
How much does a gate keypad cost installed in West Palm Beach?
A wired or wireless gate keypad typically runs $300 to $750 installed in West Palm Beach. That covers the unit and standard labor on an existing operator. If the gate needs new wiring or a control-board interface, the total climbs. Call (855) 360-5979 for an exact quote – estimates are free.
Is it cheaper to repair or replace my gate access system?
Repair is almost always cheaper when the operator still works – a keypad, reader, or loop-detector fix runs $180 to $900, versus $650 to $1,600+ for a new package. We diagnose the actual failure first, because a dead keypad is often a cheap wiring or board issue, not a reason to replace the whole system. Call (855) 360-5979 and we’ll tell you straight which path makes sense.
How much does commercial gate access control cost?
Commercial multi-tenant entry systems in West Palm Beach typically run $2,400 to $8,500 or more, driven by the number of lanes, video capability, and loop detectors. A single-lane commercial keypad install sits lower, near $800 to $1,500. For a site-specific number, call (855) 360-5979 – the estimate is free.
Can you add access control to the gate I already have?
In most cases, yes – and it usually costs $300 to $1,200 to add a reader to a gate with a working operator and existing power. Because we service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, we work on the brand you already have rather than pushing a replacement. Call (855) 360-5979 to confirm compatibility.
How much does an intercom or telephone entry system cost?
A telephone entry intercom runs $1,400 to $3,200 installed for residential or light commercial, and a video intercom with call-forwarding lands between $1,800 and $4,000. Commercial DoorKing-style entries with multiple tenants run higher. Call (855) 360-5979 for a written quote.
Can you come out today?
Same-day and next-day appointments are often available across West Palm Beach and the surrounding communities, and we reserve room for gates that are stuck open or locked out. Call (855) 360-5979 to check the schedule – if we can get there today, we will.
Why West Palm Beach Property Owners Call Us for Access Control
Access control isn’t a side service for us. Electric gate repair and access diagnostics are a core part of what we do, which means we’re reading control boards, tracing loop-detector faults, and testing receivers rather than guessing at them. From a DIY-installed Mighty Mule residential gate to a commercial FAAC or BFT automated system, we work the whole range with the same fluency. That brand-agnostic approach matters: customers with older or non-standard systems aren’t told their brand “isn’t supported” or quietly steered toward a new gate they didn’t need.
The name Sovereign reflects an operating standard. Every job is treated as a complete solution, not a patch, because a gate that fails again isn’t a repair. We install as well as repair, so whether you’re adding access control to an existing gate or starting from a new install, you’re getting one specialist who sees the whole system. If you’d like the broader picture of how these systems work and what ours cover, start from our home page.
Ready to know your number? Call (855) 360-5979 for a free estimate and we’ll walk your gate, check the operator, and quote real West Palm Beach pricing – no guesswork, no pressure toward a replacement you don’t need.
Pricing reflects the West Palm Beach market as of 2026. Sovereign Gate Repair offers free estimates – call (855) 360-5979.
What Our Customers Say
"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
— Brian Pruitt"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
— Shanice Grant"Fixed the immediate problem. He was honest that the operator is near end of life and I should budget for a replacement, which I appreciate even if it wasn't what I wanted to hear."
— Oscar Morales