Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateMighty Mule Gate Repair in Broadview Park, FL | Sovereign Gate Repair
We repair Mighty Mule gate operators across Broadview Park and nearby areas including Mighty Mule in Plantation, and we’ll tell you straight: most of the Mighty Mule failures we see here aren’t the opener’s fault. They’re the gate post leaning, the arm bracket shearing, or the control board corroding after a South Florida storm. As an independent gate shop, we’re not authorized or endorsed by Mighty Mule, but we work on their hardware every week and know exactly where these units fail on Broadview Park’s aging drive-gate mounts. If your Mighty Mule is stalling, reversing, or dead, call us at (855) 360-5979 for a free estimate.
Why Broadview Park Residents Choose Us for Mighty Mule Service
We work on the brand you already have. Our Mighty Mule sales & service experience covers the MM360, MM371, MM372 swing openers, the FM350 and FM500 slides, and the MM560/MM571 single-swing units that show up again and again on Broadview Park driveways. Len Cavaretta, our owner and lead technician, spent over two decades doing field work on residential and commercial gate systems across Palm Beach County before focusing on the gate brands most competitors shrug at. He’s seen the same Mighty Mule control board corrode from salt-laden humidity three times in one week, and he’ll tell you why it happened rather than swap the board and hope for the best. Our Broadview Park service area coverage means we can usually get to your gate the same day when it’s an emergency repair.
We’re also brand-agnostic in the way that matters. You’re not steered toward replacing a Mighty Mule opener just because we’d rather sell you something else. If the board, motor, and arm are all shot, we’ll say so. If a corroded battery harness or a misaligned arm bracket is the real problem, we repair what’s repairable and tell you how long you can reasonably expect it to last.
Styles & brands we work with





Common Mighty Mule Gate Repair Problems We Solve in Broadview Park
- Control board and battery-terminal corrosion. South Florida humidity and salt-laden air from the coast get inside Mighty Mule enclosures faster than you’d think. Units that ran fine all winter quit after a humid spell or a storm power flicker. We diagnose the board itself, not just the symptom.
- Sheared or bent arm brackets. On Broadview Park’s older 1950s-to-1970s concrete-block homes, the original gate posts and operator mounts were never designed for today’s heavier Mighty Mule arms. When a post leans, the opener arm gets pulled out of geometry and the bracket shears or the motor burns up.
- Post lean and footing shift. Heavy summer downpours saturate the sandy soil under Broadview Park driveways, and gate posts move. A Mighty Mule operator’s close-limit no longer catches, so the gate reverses or stalls halfway. We reset posts and re-hang gates in place rather than widening the swing onto a neighbor’s property.
- Wind-driven debris damage after named storms. Near-annual tropical storm and hurricane exposure bends operator arms, drops gates, and strips limit switches on panels hung on aging posts. After a storm passes through Broadview Park, demand spikes for realignment work and arm replacement.
- Battery backup failures. Mighty Mule battery harnesses degrade quickly in this climate, particularly on units mounted low to the ground where splash-back from canal-adjacent driveways reaches them. We test the battery under load before declaring it dead.
Mighty Mule Service in Broadview Park: What Local Conditions Mean for Your Equipment
Most Broadview Park driveways sit on narrow, tightly packed lots that back onto the neighborhood’s drainage canal easements. A sagging or misaligned Mighty Mule gate often can’t be swung wider to fix the alignment because the swing would cross over the neighbor’s property line or the swale. We reset the post and re-hang the gate in place rather than enlarge the swing. That changes how we approach Mighty Mule repair here: the fix usually isn’t a new opener arm, it’s getting the post back to plumb and re-anchoring the mount on a proper footing. On streets like SW 41st Terrace and 44th Avenue, where the original stucco-over-block columns date to the 1960s, undersized footings and rusted hinge plates are the rule, not the exception. A homeowner on SW 41st Terrace called because her Mighty Mule MM360 swing gate would open and then stall halfway; we handle similar Mighty Mule repair in Broward Estates too. We found the arm bracket sheared and the limit switch out of sync after a post on the original mid-century column had leaned from saturated sandy soil. The lot was too tight to widen the swing over the swale, so we reset and re-anchored the post in place, re-hung the gate, and replaced the arm bracket and a corroded control board. The gate has cycled cleanly since.
Mighty Mule Models & Products We Service in Broadview Park
We service the Mighty Mule MM360, MM371, and MM372 swing gate openers; the FM350 and FM500 slide gate openers; MM560 and MM571 single-swing operators; and the MMS100 and MMS200 slide gate kits with keypad and remote accessories. When a control board, arm, or battery backup is still available from Mighty Mule, we use the OEM part because the mating geometry matters. When OEM is discontinued or priced far beyond what the unit is worth, we use quality aftermarket gears and hinges. We keep common Mighty Mule arm brackets, limit switches, and battery harnesses stocked locally so Broadview Park turnarounds stay short.
See the difference
Before
After
Before
After
Before
AfterMighty Mule Service Pricing in Broadview Park
Mighty Mule gate repair in Broadview Park typically runs $185 to $420, depending on what failed. A limit switch replacement or arm bracket is on the lower end. A control board replacement is on the higher end. A full motor replacement with realignment work runs higher. Here’s what you’re looking at:
- Diagnostic service call: $75 to $125, applied toward the repair if you proceed
- Arm bracket replacement: $185 to $260
- Limit switch replacement and realignment: $170 to $290
- Control board replacement (OEM): $280 to $420
- Battery backup replacement: $150 to $250
- Post reset and re-hang with opener re-setup: $350 to $600 depending on footing work
We quote the full price before any work starts, and the number you agree to is the number you pay. Our free estimate covers the diagnostic, the parts, and the labor as one figure. Call (855) 360-5979 and we’ll talk through what your Mighty Mule is doing.
Serving Broadview Park, FL — Our Local Coverage Area
We’re based in the Broadview Park area and know this community well, and we also provide Mighty Mule service in Fort Lauderdale. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Mighty Mule Gate Repair in Broadview Park
It’s usually the gate, not the operator. On Broadview Park’s aging concrete-block drive-gate mounts, a post that’s leaned even a few degrees throws the Mighty Mule arm out of geometry, and the close-limit never catches. We check the post plumb first, then the limit switch, then the board. Call (855) 360-5979 for a diagnostic.
South Florida humidity, salt-laden air from the coast, and storm-driven moisture get into the control board and battery terminals. Units mounted low to the ground near canal-adjacent driveways get splash-back. The corrosion is the problem, not normal wear. We replace the corroded board or harness and seal the enclosure properly.
Yes. Most Broadview Park lots are too narrow to enlarge the swing over the swale or the neighbor’s property line. We reset the post and re-hang the gate in place, then re-set the opener’s open and close limits. It’s the standard repair here, not the exception.
We do. OEM Mighty Mule control boards, arms, and battery backups are still available for many FM350 and MM360 units, and we keep common brackets and harnesses stocked locally for faster Broadview Park turnaround. If OEM is discontinued, we’ll tell you before using aftermarket. Call (855) 360-5979 to check your model.
Sometimes the opener itself survived, but the gate is dropped or the arm is bent and the limit switches are stripped. We realign the gate, replace the arm if it’s bent, and re-set the limits. If the control board took water, we replace it too. Call us after a storm and we’ll assess the whole system for one price.
Service Areas Near Broadview Park
We serve Broadview Park and the surrounding South Florida communities, including Hobe Sound, Boca Raton, Boca Del Mar, Boca Pointe, Sandalfoot Cove, and Deerfield Beach. For clients in those areas, see our Mighty Mule service in Port Saint Lucie page. For neighbors to the south, we cover Mighty Mule service in Pine Island Ridge as well.
Book Your Mighty Mule Service in Broadview Park Today
If your Mighty Mule in Lauderhill or Broadview Park is stalling, reversing, or dead, call (855) 360-5979. We’ll diagnose the real problem, quote the full price before any work starts, and in most storm-related cases get to your Broadview Park gate the same day. Estimates are free.
Written by Len Cavaretta, Owner & Lead Technician at Sovereign Gate Repair, serving Broadview Park and South Florida since 2003.