Electric Gate Repair in Tequesta — On-Site in 60 Minutes, Fixed the Same Day

Fast, Reliable Electric Gate Repair Across Tequesta

Electric gate repair in Tequesta usually runs $180 to $340 for most service calls, and the majority of jobs are completed in a single visit. If your gate is stuck open, won’t close, or stopped responding after a storm, a trained technician can typically diagnose the problem and fix it the same day. Call (855) 360-5979 and we’ll get you on the schedule.

Call (855) 360-5979

We work throughout Tequesta, from the riverfront properties along Tequesta Drive and Riverside Drive to the golf-community enclaves off Country Club Road and the newer gated developments near the south end of the village. Salt air pushing up the Loxahatchee River and through Jupiter Inlet means the gate hardware here doesn’t age the way it does fifteen miles inland. We know what to look for before we even pull into the driveway.

Sovereign Gate Repair handles the full electrical side of your gate system: motors, operators, control boards, loop detectors, keypads, remotes, safety sensors, and the wiring between all of it. We’re not a handyman service that occasionally looks at a hinge. Electric gate diagnostics is what we do every day.

Tequesta’s Salt Air Is Hard on Gate Systems

If you live along the water or within several blocks of the river or inlet, your gate is aging faster than a comparable gate in Jupiter Farms or Palm Beach Gardens. Salt-laden ocean air pushes up the Loxahatchee River and settles into the metal on your gate, your hinges, your keypad, and your operator control board. We see keypads where the buttons have oxidized enough to stop registering digits. We see control boards with white corrosion blooming across the terminals. We see hinge post bolts so rusted that the gate sags and drags on the drive.

This is a specific Tequesta problem. Inland crews don’t see this pattern, and they often misdiagnose it as a bad motor or a failed board when the issue is actually corrosion at a connection point or a hinge that needs re-seating. We replace rusted hardware with stainless, we seal enclosures that weren’t sealed properly in the first place, and we lubricate moving parts with marine-grade products that actually hold up in this environment.

A gate that fails again in eight months isn’t a repair, it’s a callback. We build our Tequesta jobs around the assumption that the salt is going to keep coming. That changes what parts we use and how we install them.

Why Sovereign Gate Repair Is Tequesta’s Preferred Electric Gate Repair Company

Len Cavaretta founded Sovereign Gate Repair around a simple principle: fix the system, not just the symptom. Our technicians are certified to service nine industry gate brands including FAAC, BFT, Linear, and Viking, which means when we pull up to a Tequesta property, we’re not guessing at someone else’s operator. We’ve worked on it before.

Tequesta homeowners call us because they’ve already tried the generalist route. Maybe a handyman replaced a battery and the gate worked for a week. Maybe another company told them their older FAAC unit was obsolete and needed a full replacement. We walk in with the diagnostic equipment and the brand familiarity to tell you what’s actually wrong, and often it’s a $200 fix on a gate that another company wanted to replace for $6,000.

Our Electric Gate Repair team serves residential and commercial properties across the 33469 ZIP code. From Mighty Mule residential drive gates to commercial-grade FAAC and BFT automated systems on estate properties, we’re factory-familiar with the brand you already have. We don’t steer Tequesta customers toward replacing a system just because we don’t like the brand on the box.

We handle gate repair, electric gate repair, and gate installation. That means when we open up your operator and tell you the board is fried, we can also tell you whether it’s worth repairing, what a replacement would cost, and whether a newer operator would actually give you meaningfully better performance in this coastal climate. That’s the Sovereign standard: complete solutions, not patches that remind you they’re temporary the next time a squall rolls through.

Call (855) 360-5979 for a free estimate. We’ll give you a written price before any work starts, and the number we quote is the number you pay.

Automatic Gate Repair in Tequesta

Automatic gate repair in Tequesta often comes down to one of three things: an operator arm that’s out of adjustment after wind load flexed the gate, a control board that’s corroded from salt exposure, or a sensor loop that’s been damaged by saturated ground shifting the driveway. The repair itself typically runs $180 to $340 depending on what we find once we open the panel and test the system.

When you live near the river or the inlet, your automatic gate matters more than a typical driveway gate. In a power cut or a storm, you need to know you can open and close that gate by hand. That’s why we walk every Tequesta homeowner through the manual-release procedure after we finish a repair. It takes thirty seconds to learn and it changes everything when the water is rising or you need to get a car out.

Storm Damage and Gate Re-Setting

After a serious weather event, we’re usually the second call after the generator company. A gate that worked perfectly the day before the storm suddenly won’t close, or it closes and reopens itself, or the operator makes a grinding noise. What happened is usually wind load. The gate itself flexed in the wind, pulled the hinge posts slightly out of alignment, and now the operator arm is fighting a gate that’s no longer sitting where the limits expect it to be. We re-set the hinge posts, correct the sweep, and re-calibrate the operator limits so the gate cycles cleanly without strain.

Manual-Release During a Power Cut

Your gate operator has a mechanical release that disengages the motor so you can push the gate open by hand. On most residential swing gates, it’s a pull handle or key mechanism on the operator itself. On slide gates, there’s usually a release bolt or a lever near the drive chain. We’ll show you exactly where it is on your specific model and make sure it’s in working order as part of every repair visit.

This matters in Tequesta. Power cuts here come with summer storms and hurricane season, and if you can’t open your gate, you can’t leave your property, and emergency services can’t get in.

Electric Gate Motor in Tequesta

Electric gate motor repair in Tequesta means diagnosing whether the failure is the motor itself or the electronics that drive it. We test line voltage to the motor, check the capacitor if the operator uses one, and confirm the control board is sending the right signal before we ever pull a motor off the mount. Typically you’ll spend $220 to $400 for a motor-level repair, depending on the brand and whether the issue is a bad capacitor, a seized gearbox, or a complete motor swap.

If your gate makes a humming noise but doesn’t move, or it moves a few inches and stops, the motor is the most likely culprit. But motors fail for reasons here. A corroded housing lets salt moisture into the windings. A gate that’s been out of alignment for months makes the motor work harder than it should, and eventually the thermal overload trips enough times that something gives. We fix the motor and we fix what killed the motor, so you’re not back on the phone in a year.

Operator Arm and Gearbox Service

The arm that pushes and pulls your swing gate takes a beating in coastal wind. Worn bushings, stripped gears, or a bent arm from the gate being forced open during a storm all land on the workbench here. We stock common replacement components for FAAC, BFT, and LiftMaster operators, which means we can often complete the repair the same day instead of ordering a part and coming back.

Control Board Diagnostics

The control board is the brain of the system, and in Tequesta, it lives a harder life than it should. Salt corrosion creeps into the enclosure, bridges connections, and randomly activates the gate or kills it entirely. We open every board, inspect the terminals and the back side of the PCB for corrosion, and replace sealed enclosures where water intrusion was the real issue. Sometimes the board is fine and the symptom is a corroded connection, which is a cheaper fix than a new board.

Call (855) 360-5979 and describe what your gate is doing. We’ll tell you over the phone whether it sounds like a motor, a board, or something simpler, and schedule a visit.

Trusted Brands We Service in Tequesta

We don’t ask what brand your gate is. We ask what it’s doing. Sovereign Gate Repair is factory-familiar with nine brands including FAAC, BFT, Linear, and Viking, and we service both residential and commercial-grade systems. That’s a meaningful difference when you own a gate the previous company declined to touch. We work on the brand you already have, and we keep common repair components locally available for Tequesta customers so a simple motor repair doesn’t turn into a two-week wait for a part.

Common Electric Gate Repair Problems We See in Tequesta Homes

• Salt-corroded keypads and control boards: Salt air from the Loxahatchee River and Jupiter Inlet works its way into every exposed connection. Keypads stop reading digits, boards start acting erratically, and the gate opens or closes on its own. We replace with sealed, stainless units built for exactly this environment.
• Storm-flexed gates and shifted posts: Wind load on a solid infill gate moves the gate itself, and over time the hinge posts move too. The operator starts grinding, the gate drags, and the motor burns out trying to compensate. We re-set posts, re-align the gate, and re-calibrate the operator.
• Water intrusion in operator enclosures: The summer rainy season plus high humidity means enclosures that aren’t properly sealed collect condensation. That kills control boards faster than anything else. We re-seal enclosures on every repair and replace failed gaskets proactively.
• Manual-release mechanisms that don’t work: The release was never operated, the cable seized, or the owner doesn’t know where it is. Then a power cut hits and the gate is locked. We test the release on every visit and make sure you can open your gate by hand when the power is out.

Pricing for Electric Gate Repair in Tequesta, FL

We Also Serve Cities Near Tequesta

Sovereign Gate Repair is based in West Palm Beach and serves Electric Gate Repair in Tequesta along with nearby communities including Jupiter, Limestone Creek, Juno Beach, and Hobe Sound. If you’re just outside the 33469 ZIP code and need a gate specialist who understands coastal corrosion and storm-rated hardware, call (855) 360-5979.

FAQs About Electric Gate Repair in Tequesta

We Were Called to a Riverfront Home Off Tequesta Drive

A LiftMaster swing gate operator had stopped responding after a summer squall. The sealed control board was fine, which is usually the first suspect. The real problems were a keypad with enough salt corrosion on the contacts that it wouldn’t register more than two digits, hinge-post bolts that had rusted thin and let the gate sag, and a post footing that had shifted in ground saturated by weeks of rain. We replaced the keypad with a sealed stainless unit, corrected the sag at the hinge post, re-set the footing, and re-calibrated the operator arm so the gate cycled cleanly. Before we left, we walked the owner through the manual-release procedure so they could get the gate open by hand during the next power cut. That’s the job: fix the system, not just the part that broke first.

Written by Len Cavaretta, Owner at Sovereign Gate Repair, serving Tequesta and the surrounding coastal communities with electric gate repair, diagnostics, and installation.