Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Lantana, FL
Gate installation in Lantana means planning for salt air, hurricane wind loads, and posts set in sandy fill that shifts after hard rain. We install automatic, sliding, and driveway gates that hold their alignment on concrete-block homes and villas built between the 1950s and 1970s, where the existing hardware has often corroded past the point of rebuilding. If you need a new gate or a full replacement of an aging system, call Sovereign Gate Repair at (855) 360-5979 and we’ll quote the job before any work starts.
Why Lantana Homes Are Different
Lantana’s housing stock works against gate hardware in ways an inland installer rarely sees. Homes along the Intracoastal and in the older 33462 lots sit close enough to salt water that steel hinges, track rollers, and operator enclosures rust through faster than they would ten miles west. We’ve pulled gate frames in Lantana where the bottom rail had thinned to paper from years of brackish spray, even though the top rail looked fine to the homeowner.
The second Lantana problem is what the gate is bolted to. Many older lots near the water are built on sandy fill a few feet above the water table. After a heavy summer storm, the fill settles and aluminum or steel posts heave out of plumb. A gate that suddenly sticks or drags on the latch side is often not a hinge issue at all. The post has moved. That changes the repair: you either re-set the footing or you keep grinding the latch plate every season, which no one should accept as a repair.
Hurricane-season wind loads are the third factor. Gates here act as big sails. Weak post bases, thin aluminum frames, and under-sized operator arms fail when a squall line pushes through. We install and repair with the assumption that every gate in Lantana will see sustained wind at some point, so hardware selection matters more than it does in a sheltered inland subdivision.
Styles & brands we work with
Our Main Lantana Services
Most calls we take in Lantana fall into two categories: mechanical gate repair and electric gate repair. Here is what each one actually involves in this town.
Gate Repair in Lantana
Mechanical gate repair covers hinges, posts, rollers, tracks, latch hardware, and frames. On Lantana’s older masonry and aluminum gates, the steel hardware rusts first, then the gate sags and starts dragging across the driveway. We realign, replace corroded fasteners, and re-set posts that have shifted in sandy soil. The goal is to stop the wear pattern, not just lube it and leave. Gate Repair in Lantana covers the full scope of what we do on mechanical systems, including same-visit fixes for gates that won’t close.
Electric Gate Repair in Lantana
Electric gate repair is a separate discipline, and it’s the service Lantana property managers call us for most often. Salt air corrodes control board terminals, loop detectors fail after repeated storm-season power surges, and operator arms that were never sized for wind exposure burn out young. We diagnose motor, board, and access system failures rather than guessing. Electric Gate Repair in Lantana explains how we trace an electrical fault from the keypad or loop back to the operator itself.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Lantana
New gate installation in Lantana starts with two questions: what is the gate anchored to, and what will the salt air do to it in five years. Most homes here are mid-century concrete-block construction, which means older posts are often set in fill or tied into a low masonry wall that has already moved. We measure for rack, check the post footings, and size the operator so the gate works on the first stormy day, not just on a calm afternoon. Sovereign Gate Repair has served Lantana since 2015, and our Gate Installation process is built around the idea that the install has to survive this specific climate.
Automatic Gate Installation
Signs you need it
You’re getting out of the car to open the gate every time, or the old chain-drive operator has failed and replacement parts are no longer made for it.
What it costs in Lantana
Automatic gate installation in Lantana typically runs $4,800 to $9,200, depending on operator type and whether the posts need to be re-set before the operator can be mounted.
How we do it
We evaluate the gate weight and post bases first, then install the operator arm, run conduit for power and safety loops, and program limit settings on site so the gate opens and closes fully without slamming.
Driveway Gate Installation
Signs you need it
Your current gate no longer closes squarely, drags on the driveway, or was never automated and you want controlled access without replacing the entire fence line.
What it costs in Lantana
A new driveway gate in Lantana usually falls between $6,000 and $10,500, with the spread driven by gate width, material, and whether we’re tying into existing masonry pillars or setting new posts.
How we do it
We set posts in concrete below the settled fill line, hang the gate level, then mount and wire the operator so the leaf moves smoothly and latches under power.
Sliding Gate Installation
Signs you need it
Your driveway slopes or your property line sits too close to the street for a swinging gate, and you need a gate that slides parallel to the fence instead of arcing into the yard.
What it costs in Lantana
Sliding gate installation in Lantana typically runs $5,200 to $9,800, with cantilever hardware and a concrete track base as the main cost variables.
How we do it
We pour a reinforced track footing, set the steel or aluminum frame, install the roller trucks and catch posts, then wire the operator and safety edges so the gate reverses if it meets resistance.
What Gate Installation Costs in Lantana
| Item | Typical range in Lantana |
|---|---|
| Automatic gate installation | $4,800 – $9,200 |
| Driveway gate installation | $6,000 – $10,500 |
| Sliding gate installation | $5,200 – $9,800 |
Do I need a permit for a new gate in Lantana?
Lantana typically requires a permit for new gate posts and any electrical run to an operator, and setback rules apply differently on waterfront lots. We handle the permit paperwork as part of the installation and confirm requirements with the town before we dig or pour.
Can you match an existing fence style in Lantana?
Yes. We match aluminum and wrought-iron styles common on Lantana’s mid-century masonry walls and have the gate fabricated to the same rail spacing and finish, then hang it on hardware rated for salt exposure. The goal is a gate that looks original to the property, not a bolt-on.
Brands We Service in Lantana
We carry diagnostic equipment and common parts for FAAC, BFT, Linear, and Viking systems, which covers most of the operators running on older Lantana properties. Stocking parts locally means a bad control board doesn’t have to wait a week on a freight truck. For details on the full range of what we support, see our brands.
Pricing for Gate Company in Lantana, FL
| Service | Typical range in Lantana |
|---|---|
| Automatic gate installation | $4,800 – $9,200 |
| Driveway gate installation | $6,000 – $10,500 |
| Sliding gate installation | $5,200 – $9,800 |
| Gate hinge replacement | $175 – $500 per hinge |
| Gate post re-setting | $400 – $1,100 |
| Gate wheel or roller replacement | $145 – $450 |
| Gate motor replacement | $550 – $1,500 |
| Control board replacement | $450 – $1,200 |
| Operator arm replacement | $400 – $975 |
| Electric gate service call | $85 – $185 |
Prices in Lantana get pushed up by post re-setting on sandy or water-adjacent lots and by any wiring that has to be re-run after salt corrosion has eaten through conduit. Whatever the job, you get a written price before we start, and we do not bill above that number unless you approve a change in writing first.
See the difference
Before
After
Before
After
Before
AfterNeighborhoods We Serve in Lantana
We cover the full 33462 ZIP code, from the Intracoastal-side streets up through the neighborhoods east and west of Dixie Highway. Response time across Lantana is short because our West Palm Beach shop is close enough that a morning diagnostic call usually turns into an afternoon fix on mechanical issues.
- Hypoluxo Island
- Moorings at Lantana
- Lantana Pines
- Ocean Breeze
- Lantana Cascade
Service Area – Cities Near Lantana
In addition to Lantana, we service the surrounding communities along the Intracoastal and the barrier island edge. Gate hardware doesn’t respect city boundaries, so we run the same salt-rated installation and repair standards in South Palm Beach, FL, Hypoluxo, FL, Atlantis, FL, and Seminole Manor, FL. If your property sits on the line between two of these towns, call and we’ll confirm coverage.
Serving Lantana, FL — Our Local Coverage Area
We’re based in the Lantana area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Lantana
Mechanical gate issues like a dropped hinge or a stuck sliding gate can often be diagnosed and repaired the same day you call, since our shop is a short drive from most 33462 addresses. Electric gate diagnostics are scheduled within a day or two so we can bring the right board or motor for the brand you have.
Many of Lantana’s waterfront and 55+ communities have architectural review standards for gate height, material, and color, and some require board approval before installation. We can provide the spec sheet and drawings your HOA asks for, and we’ve worked enough Lantana communities to know what typically passes review the first time.
Yes, and that’s most of what we do here. Many Lantana gates were installed years ago by a fencing contractor or a single-brand dealer who is no longer around. We repair the gate you have, regardless of who put it in, and we only recommend replacement when the frame or footing is genuinely beyond saving.
Contact Sovereign Gate Repair in Lantana
If your gate is sagging, rusting, or refusing to open on command, call (855) 360-5979 for a free estimate. We’ll diagnose the problem, give you a written price, and do the work so it holds up to Lantana’s salt air and summer storms – not just until next season.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Lantana Customers Say
"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
— Shanice Grant"Fixed the immediate problem. He was honest that the operator is near end of life and I should budget for a replacement, which I appreciate even if it wasn't what I wanted to hear."
— Oscar Morales"Our slide gate had been dragging for months and getting worse. Turned out the chain was stretched and one of the guide rollers had seized. Both replaced, and he adjusted the limits so it stops properly at both ends now."
— Keisha Carter