Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across The Acreage
Electric gate repair in The Acreage typically runs $225 – $475 for most operator, board, and sensor failures, with full motor replacements landing between $850 and $2,200 depending on the gate’s length and the condition of the existing power run. Most calls we handle in the 33412 ZIP are same-week, often next-day for a dead operator that has a property locked in or livestock at risk. If your gate just failed, call us at (855) 360-5979 and we’ll walk you through what we’re likely to find before we even roll a truck.
We know the lot sizes out here. We know the unpaved driveways, the long fence lines, the horse fencing that runs right up to the gate post. And we know that a gate failure in The Acreage is not the same job as a gate failure in a gated subdivision in Royal Palm Beach. The drive out is different, the gate is different, and the repair usually is too.
Why Sovereign Gate Repair Is The Acreage’s Preferred Electric Gate Repair Company
The Acreage is a sprawling, unincorporated equestrian-residential community of multi-acre lots where nearly every property runs on private well water and a private driveway gate. Many residents keep horses, so gates are as often livestock and arena gates and long ranch-style entry gates as they are decorative driveway gates. Repairs have to handle both. We service Viking, Ghost Controls, DoorKing, and Elite systems out here, plus the LiftMaster, FAAC, and BFT operators other shops won’t touch because they’re not factory-familiar with the boards.
Electric gate diagnostics, not just mechanical fixes. That’s the difference. A general handyman can lube hinges and call it a day. We trace the fault on the control board, check the loop detector, test the safety sensors, and measure the load the operator is actually pulling against the gate’s weight. When a gate on a 2.5-acre lot off 60th Street North trips a breaker every time it cycles, the answer is rarely just “new motor.” It’s usually an undersized operator on a heavy swing gate fed by an old direct-buried wire.
Led by Len Cavaretta, our team handles both residential and commercial gate systems under one roof. From Mighty Mule to FAAC, residential driveways to commercial access gates, we work on the brand you already have. A gate that fails again isn’t a repair. It’s a callback. We don’t do callbacks.
Styles & brands we work with
Electric Gate Motor in The Acreage
Electric Gate Motor replacement in The Acreage usually means working around direct-buried wire that was never run through conduit because the builder saved a trench for something else. On a 1.25- to 5-acre lot, that changes the job. We’re not swapping a motor on a clean conduit stub-out. We’re excavating, running proper power, setting a post that won’t lean in sandy soil, and only then mounting and programming the operator.
Most motor replacements here run $850 to $2,200, depending on gate length, weight, and whether we’re reusing the existing feed or trenching a new one. We quote the full number before any work starts. You agree to the price, then we start.
Motor Diagnostics vs. Motor Swaps
A lot of The Acreage gates have builder-grade operators that were paired with gates far heavier than the motor was rated for. The board burns. The capacitor swells. The breaker trips. We diagnose before recommending replacement, because swapping a motor without fixing the root cause just kills the next one faster.
Long Swing Gates and Ranch Gates
Long ranch-style swing gates put enormous load on operators. When the arm has to throw a 20-foot gate on sandy ground with a post that has shifted two degrees off plumb, the motor works against the alignment every cycle. We address the footing and the geometry first. Then the operator does its job without fighting the install.
Gate Access Control in The Acreage
Gate Access Control in The Acreage means keypads, remote controls, loop detectors, and the occasional intercom or card reader for commercial properties. On residential lots out here, most callers need a new keypad paired to an older board, a remote programmed after a battery swap went wrong, or a loop detector that has stopped sensing a vehicle on gravel. Typical access control repairs run $165 – $385 for keypads, remotes, and loop work.
We were called to a property off 60th Street North where a LiftMaster operator on a long ranch-style swing gate had died after a summer lightning surge. The control board and one arm were both cooked. Pulling the old run exposed direct-buried wire under gravel and sandy soil with no conduit, so we re-ran power and conduit to a proper post footing and swapped in a fresh operator. The gate swings clean now and the next storm won’t take out a board that isn’t protected.
Keypads and Remote Programming
When a keypad stops accepting codes but the gate still operates from a remote, the issue is almost never the whole access system. It’s a failed keypad relay or a board input that has gone dead. We test the signal path and replace only what failed.
Loop Detectors on Gravel Drives
The Acreage’s unpaved and gravel driveways create a specific loop-detector problem: the loop wire sits closer to the surface than on an asphalt or concrete driveway, and vehicular wear plus soil shifting breaks the loop. We repair and tune loop sensitivity so the gate opens for cars, not for every thunderstorm that passes overhead.
Trusted Brands We Service in The Acreage
Certified to service Viking, Ghost Controls, DoorKing, and Elite, plus LiftMaster, FAAC, BFT, Linear, and Mighty Mule. That’s nine brands across residential and commercial grade. For The Acreage customers, that matters because most of these operators have been installed by different contractors over the years, and the gate you’re running doesn’t care whether the new guy knows the board architecture. We carry common boards, remotes, and sensor kits for these brands or can source them within days. A brand-agnostic service model means we’re not steering you into replacing a Viking operator because we don’t understand the fault code.
Common Electric Gate Repair Problems We See in The Acreage Homes
- Builder-grade operators tripping breakers: On newer Acreage lots, the original operator was often sized for a light decorative gate and got paired with a long, heavy swing gate. The breaker trips, the board cooks, and the homeowner thinks the whole system is dead.
- Direct-buried power runs with no conduit: Most gates out here were built on plots that were never trenched for a dedicated power or conduit run. When the wire fails, replacing an operator means trenching a real feed instead of chasing a wiring fault.
- Shifted post footings in sandy soil: Sandy soil lets gate posts lean and shift. A half-inch of movement at the hinge post becomes a full misalignment at the latch, which makes the motor work harder and eventually burns it out.
- Lightning-surge board failures: Summer thunderstorms in South Florida send surges through gate wiring with no protection. The board takes the hit, the gate stays closed, and the horses stay in. Surge protection work is part of a proper repair out here.
See the difference
Before
After
Before
After
Before
AfterPricing for Electric Gate Repair in The Acreage, FL
Electric gate motor replacement in The Acreage: $850 – $2,200. Control board replacement: $325 – $750. Keypad or remote repair: $165 – $385. Safety sensor alignment or replacement: $150 – $320. Full conduit and power re-run to the gate post: $600 – $1,400 depending on distance and whether we’re trenching through gravel, grass, or past a horse fence. The two factors that move price more than anything else out here are the length and weight of the gate and whether the existing power feed can be reused. We quote the job in writing before we start, and that number does not change without your approval. Call (855) 360-5979 for a free estimate.
We Also Serve Cities Near The Acreage
Our service area reaches beyond the 33412 ZIP. We handle Electric Gate Repair in The Acreage daily, and we also run calls through Royal Palm Beach, Palm Beach Gardens, Haverhill, and Lake Belvedere Estates. If your gate is down and you’re on the edge of The Acreage, call and we’ll sort out coverage.
Serving The Acreage, FL — Our Local Coverage Area
We’re based in the The Acreage area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in The Acreage
Yes, we add automation to manual gates regularly in The Acreage. The real work is the power feed: most manual gates out here never had a conduit or dedicated circuit run to the post. We trench the feed, set a proper post footing if needed, and mount an operator matched to the gate’s actual weight and sweep. Call (855) 360-5979 for an exact quote.
It depends on what’s buried. A lot of The Acreage gates are fed by direct-buried wire with no conduit at all. If the insulation is intact and the wire gauge is adequate for the operator, we can sometimes reuse it. But when a lightning surge or years of sandy soil exposure have compromised the run, you’ll need new conduit. We always inspect before recommending.
Lightning damage is common in The Acreage’s summer storm season, but it’s not something you have to accept. We install surge protection at the operator and at the breaker panel, and we make sure the gate system is properly grounded. A board that keeps dying is usually a wiring problem, not an act of God. Call (855) 360-5979 and we’ll trace it.
Yes. Livestock gates, arena gates, long ranch-style entry gates, pipe-frame gates on horse fencing: we handle them all. These gates are heavier, longer, and often mounted on posts set in sandy soil that shifts. We repair the gate geometry, the footing, and the operator as one system.
Usually no. A sag in the middle of a long gate means the hinge post has moved or the gate frame is flexing, and the operator is fighting that extra resistance. The motor is often fine. We correct the post, add a mid-rail or gusset if needed, and re-tension the operator. The fix is structural first, motor second. Call (855) 360-5979 for a free assessment.
Contact Sovereign Gate Repair for Electric Gate Repair in The Acreage
If your gate is down, half-open, or just loud enough to worry you, call (855) 360-5979. We’ll ask about the gate, the operator, and what it’s doing, then give you a straight answer about what it will take. Estimates are free, the price is quoted before work starts, and the repair is done to Sovereign standard. Electric gate diagnostics, not just mechanical fixes.
Written by Len Cavaretta, Owner at Sovereign Gate Repair, serving The Acreage and Palm Beach County.